There are two ways to view video when the connections are completed between a site and center
system. In order for a proper operation, an IP address must be set accordingly. Please refer to the True
Manager in Chapter 3 or Remote Setting in Chapter 4 for further details. (See True Manager manual).
Video Monitoring with Decoder System
Once the IP address is set in the remote IP address section of the decoder or the IP Camera, the
decoder system will connect to the encoder systems or the IP Camera and start receiving the video
images. Normally, a monitor connected to the decoder will display video images.
Video Monitoring using Internet Explorer
Open Internet Explorer and enter the encoder‟s IP address. The system will ask for confirmation to install
Active-X control. Once authorized, the Internet Explorer will start to display video images from the
encoder as shown below. (See Illustration Page 17).
To Next Page