Martha Stewart BELLA User Manual

Page 1 of 2
Description
QTY
Parts List
Item
P1
Step 1.
Assemble the Table on a flat, soft surface such as a carpet or cloth to prevent scratching the finish.
Hardware List
QTY
Description
Item
H1
H2
H3
Pre-assembly:
Take out all parts and hardware from box.
Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.
Important safety instructions:
Please read carefully all instructions before assembly.
For your safety and ease, assembly by two or more adults is recommended.
Keep instructions for future use.
ASSEMBLY INSTRUCTIONS
Description: BELLA DINING TABLE
Assembly Procedures:
DISCLAIMER:
WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE. SELLER IS NOT LIABLE FOR ANY DAMAGES
RESULTING FROM ITEM BEING IMPROPERLY ASSEMBLED AFTER PURCHASE.
Leg 4
P2
Table Top
1
H4
Attach Legs (P1) to the Table top (P2) using Bolt (H1) , Spring Washer (H2) , and Flat Washer (H3) using Allen key
(H4) as shown below.Tighten all bolts.
8x
P1
P1
P1
P2
Bolts M8 x 70mm
Spring Washer M8
Flat Washer M8
1
M5 Allen Key
H1
H4
H3
H2
8+1 EXTRA
8+1 EXTRA
8+1 EXTRA
P1

Martha Stewart BELLA Specifications

General

Brand	Martha Stewart
Model	BELLA
Category	Indoor Furnishing
Language	English

Summary

Important Safety Instructions

Assembly Procedures

Step 1: Attach Legs

Attach Legs (P1) to the Table top (P2) using Bolt (H1), Spring Washer (H2), and Flat Washer (H3) using Allen key (H4).

Step 2: Final Positioning

Turn the assembled table to an upright position. Assembly is complete.

Additional Safety Notes