MX-1 user manual DIP-switch settings 11
DIP-
SWITCH
SETTINGS
6
This section describes how to select the control address and special settings using
the DIP-switch on the end panel.
DMX ADDRESS SELECTION
If the MX-1 is to be used with a DMX protocol controller, then the DIP-switch
must be set to the DMX control address. The address, also known as the start
channel, is the first channel used to receive instructions from the controller. The
MX-1 uses 6 channels for full DMX operation. For independent control, each
fixture must be assigned its own address and non-overlapping control channels.
Two MX-1s may share the same address only if they are to respond identically:
they will receive the same instructions and individual control will not be possible.
To set the DMX address
1 Select an address for the fixture on your controller.
2 Look up the DIP-switch setting for the address on page 12.
3 Set pins 1 through 9 to the ON (1) or OFF (0) position as listed in the table.
4 Set pin 10 to the OFF position.
5 Set pin 11 to the OFF position for full 6-channel DMX operation or to the ON
position for 1-channel DMX operation.
To Next Page
Loading...
