28
GLASS DOOR INSTALLATION AND FAN ACCESSORY
F
AN ASSEMBLY
The model SCF42A and SCF42AI Fireplaces may be equipped with a accessory fan Model FA2. If the fireplace
is to be equipped with this accessory at anytime, the JB1 junction box assembly must be installed on the
fireplace as shown by Figures 32 and 33 during the installation of the fireplace. Unless the JB1 junction box is
installed at this time, wall finishing materials must be removed to gain access to the side of the fireplace to
install the JB1 junction box at a later date. Complete Installation and Operation Instructions for the FA2 Fan
are included in the package with this accessory.
Note: A rectangular switch knockout is provided on the lower right hand face of the fireplace.
GLASS DOOR INSTALLATION
This fireplace has been tested and listed for use with optional Model GD42P or GD42PB glass doors. For
installation of the Models GD42P or GD42PB glass doors, see the instructions provided with the doors.
NOTE: THE THREE PRONG RECEPTACLE
AND ITS COVER MUST BE EXPOSED AND
THE COVER PLATE MUST BE REMOVABLE
FOR INSPECTION OF WIRING CONNECTION
ONCE THE FIREPLACE IS INSTALLED.
FASTEN MODEL JBI JUNCTION
BOX TO THE SIDE OF THE
FIREPLACE WITH THE TWO
SHEET METAL SCREWS REMOVED
FROM JUNCTION BOX
OPENING COVER.
JUNCTION BOX
OF FIREPLACE
TO FUSE OR
CIRCIUT BREAKER
GROUND
WHITE
BLACK
NOTE: THE JB1 JUNCTION BOX SHOULD BE INSTALLED AND THE RECEPTACLE WIRED TO THE E
NOTE: THE JB1 JUNCTION BOX SHOULD BE INSTALLED AND THE RECEPTACLE WIRED TO THE E
LECTRICAL SYSTEM OF
THE STRUCTURE AT THE TIME OF INSTALLATION OF THE FIREPLACE OF THE FA
THE STRUCTURE AT THE TIME OF INSTALLATION OF THE FIREPLACE OF THE FA
2 FAN ASSEMBLY IS TO BE USED.
2 FAN ASSEMBLY IS TO BE USED.
SWITCH
(SPST)
CORDSET
120V, 60HZ
(FAN ASSEMBLIES)
M2
GAS APPLIANCE
OPENING COVER
JUNCTION BOX
OPENING COVER
MODEL JBI JUNCTION BOX INSTALLATION
REMOVE JUNCTION BOX
COVER FROM FIREPLACE.
BELK LOUVER KIT
FIGURE 32
FIGURE 33
53D9022. Rev 1 03/03
To Next Page
Loading...
Need help?
General
