Martin DESIGNER User Manual

DIRECT VENT GAS FIREPLACE
INSTALLATION AND OPERATING
INSTRUCTIONS
MODEL: DESIGNER
WARNINGS
IF THE INFORMATION IN THESE INSTRUCTIONS ARE
NOT FOLLOWED EXACTLY, A FIRE OR EXPLOSION
MAY RESULT CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF LIFE.
– Do not store or use gasoline or other ammable
vapors and liquids in the vicinity of this or any
other appliance.
– WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call the
re department.
– Installation and service must be performed
by a qualied installer, service agency or the
gas supplier.
WARNING: Improper installation, adjustment,
alteration, services or maintenance can cause injury or
property damage. Refer to this manual. For assistance
or additional information consult a qualied installer,
service agency or the gas supplier.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is
not convertible for use with other gases, unless a
certied kit is used.
This appliance may be installed in an aftermarket*,
permanently located, manufactured home, where not
prohibited by local codes.
*Aftermarket: Completion of sale, not for purpose of resale, from
the manufacturer.
DUE TO HIGH TEMPERATURES, THE
APPLIANCE SHOULD BE LOCATED OUT
OF TRAFFIC AND AWAY FROM FURNITURE
AND DRAPERIES.
CHILDREN AND ADULTS SHOULD BE
ALERTED TO THE HAZARDS OF HIGH
SURFACE TEMPERATURE AND SHOULD
STAY AWAY TO AVOID BURNS OR CLOTHING
IGNITION.
YOUNG CHILDREN SHOULD BE
SUPERVISED WHEN THEY ARE IN THE
SAME ROOM AS THE APPLIANCE.
CLOTHING OR OTHER FLAMMABLE
MATERIAL SHOULD NOT BE PLACED ON
OR NEAR THE APPLIANCE.
KEEP THE ROOM AREA CLEAR AND
FREE FROM COMBUSTIBLE MATERIALS,
GASOLINE, AND OTHER FLAMMABLE
VAPORS AND LIQUIDS.
READ BEFORE INSTALLING. SAVE THESE INSTRUCTIONS

Martin DESIGNER Specifications

General

Brand	Martin
Model	DESIGNER
Category	Indoor Fireplace
Language	English

Summary

Important Safety Information

General Safety Guidelines

Crucial safety instructions for operation, installation, and maintenance to prevent injury or fire.

Code Approval

Product Features

Product Specifications

Details about the appliance's certifications, fuel types, and installation approvals.

Pre-Installation Information

Installing Above 2000 Feet

Guidelines for installing the appliance at higher elevations, including derating factors.

Orifice Sizes, Pressures and BTUs

Technical specifications for gas orifices, operating pressures, and heat output ratings.

Before You Start

Instructions for initial inspection and verification of contents before installation.

Items Required for Installation

Lists of tools and building supplies necessary for the installation process.

Fireplace Location

Wall Location

Island Location

Framing Fireplace

Framing Peninsula Fireplace

Instructions and specifications for framing a peninsula-style fireplace installation.

Framing Corner Fireplace

Framing See Through Fireplace

Securing Fireplace to Floor

Clearances

Clearances to Combustibles

Guidelines for maintaining safe distances from combustible materials around the appliance.

Mantel Clearances

Specific clearance requirements for installing a mantel above the fireplace.

Installation Information

Finishing Material

Guidelines on using noncombustible materials for finishing the fireplace surround.

Vent Installation

Installation Precautions

Safety and procedural warnings before installing the venting system.

Optional Top Vent Application

Installation Planning

Horizontal Termination

Vertical Termination

Installing a Vent System in an Outside Chase

Termination Clearances for Buildings

How to Use the Vent Graph

Rear Wall Vent Installation

Horizontal Termination Configurations

Below Grade Installations

Vertical Through-the-Roof Applications

Installation for Vertical Termination

Flat Ceiling Installation

Fireplace Installation

Check Gas Type

Verifying the correct gas type for the fireplace installation.

Installing Gas Piping to Fireplace / Burner System Location

Procedures for connecting gas piping to the fireplace and burner system.

Checking Gas Pressure

Electrical Installation

Electrical Wiring

Safety and compliance guidelines for electrical wiring connections.

Remote Wall Mounted Switch

Instructions for installing and wiring a remote wall switch.

Glass Removal

Log Placement

Installing Logs and Rock Wool (Ember Material) in Firebox

Step-by-step guide for correctly positioning logs and ember material in the firebox.

Air Restrictor Adjustment

Operating Instructions

Initial Lighting

Procedure for purging air from the gas supply line before first use.

Leak Testing

Methods for checking gas supply connections and the appliance for leaks.

Approved Leak Testing Method

Lighting Pilot

Lighting Burner

Pilot Position

To Turn Off Gas

Cleaning and Maintenance

Venting System

Recommendation for annual inspection of the venting system.

Cleaning Glass

Instructions for cleaning the fireplace glass, including precautions.

Pilot and Burner Flames

Guidance on visually checking pilot and burner flames for proper operation.

Firebox Cleaning

Steps for cleaning the interior of the fireplace, including logs and burner.

Troubleshooting

Glass Replacement and Blower

Optional Blower Accessory - BLOT

Information about the optional blower accessory for the fireplace.

Wiring Diagram for Blower

Electrical schematic for connecting the optional blower.

Replacement Parts

Installation Records

Limited Lifetime Warranty Policy

Lifetime Warranty

Details on components covered under the lifetime warranty.

Five Year Warranty

Details on components covered under the five-year warranty.

Basic Warranty

Outlines the two-year warranty for manufacturing and material defects.