To Next Page

To Previous Page

14 53D0419

53D0419 15

Read all instructions completely and thoroughly before attempting installation. Failure

to do so could result in serious injury, property damage or loss of life. Operation of

improperly installed and maintained venting system could result in serious injury,

property damage or loss of life.

WARNING

Failure to follow these instructions will

void the warranty.

NOTICE

INSTALLATION PRECAUTIONS

NOTE: This appliance must be installed with a Monessen approved venting system only.

Consult local building codes before beginning the installation. The installer must make sure to select the proper vent system

for installation. Before installing vent kit, the installer must read this replace manual and vent kit instructions.

Only a qualied installer/service person should install venting system. The installer must follow these safety rules:

• Wear gloves and safety glasses for protection.

• Use extreme caution when using ladders or when on rooftops.

• Be aware of electrical wiring locations in walls and ceilings.

The following actions will void the warranty on your venting system:

• Installation of any damaged venting component.

• Unauthorized modication of the venting system.

• Installation of any component part not manufactured or approved by Monessen.

• Installation other than permitted by these instructions.

FINISHING MATERIAL

NOTE: Any remote wiring (i.e. remote control, wall switch, and optional fan) must be done prior to final

finishing to avoid costly reconstruction.

INSTALLATION INFORMATION

Only noncombustible materials (i.e. brick, tile, slate, steel, or other materials with a UL re rating of Zero) may be used to

cover the black-painted face of the appliance. A 300°F minimum adhesive may be used to attach facing materials to the black

surface. If joints between the nished wall and the replace surround are sealed, a 300°F minimum sealant material (General

Electric RTV103 or equivalent) must be used. Combustibles may come to the top and side edges but not overlay the face.

Never obstruct or modify the air inlet or outlet grills (louvers). This may create a

fire hazard.

WARNING

VENT INSTALLATION

Martin DESIGNER User Manual

Questions and Answers: