Martin DESIGNER User Manual

8 53D0419
53D0419 9
PRE-INSTALLATION INFORMATION
This gas replace should be installed by a qualied installer in accordance with local building codes and with current CAN
/CGA-B149 (.1 or .2) Installation codes for Gas Burning Fireplaces and Equipment. If the unit is being installed in a mobile
home the installation should comply with the current CAN/CSA Z 240 .4 code.
FOR U.S.A Installations follow local codes and/or the current National Fuel Gas Code. ANSI Z223.1.
FIREPLACE LOCATION
FOR SAFE INSTALLATION AND OPERATION PLEASE NOTE THE FOLLOWING:
INSTALLATION AND OPERATING INSTRUCTIONS
THIS APPLIANCE HAS BEEN APPROVED FOR AFTER-MARKET MOBILE HOME INSTALLATIONS.
1. This replace gives off high temperatures and should be
located out of high trafc areas and away from furniture
and draperies.
2. Children and adults should be alerted to the hazards of
the high surface temperatures of this replace and should
stay away to avoid burns or ignition of clothing.
3. Caution, due to high glass surface temperature children
should be carefully supervised when they are in the same
room as the replace.
4. Under no circumstances should this replace be modied.
Parts removed for servicing should be replaced prior to
operating the replace again.
5. Installation and any repairs to this replace should be
carried out by a qualied service person. A professional
service person should be contacted to inspect this re-
place annually. Make it a practice to have all of your gas
replaces checked annually. More frequent cleaning may
be required due to excess lint and dust from carpeting,
bedding material, etc.
6. Control compartments, burners and air passages in this
replace should be kept clean and free of dust and lint.
Make sure that the gas valve and pilot light are turned
off before you attempt to clean this replace.
7. The venting system (chimney) of this replace should be
checked at least once a year and if needed your venting
system should be cleaned.
8. Keep the area around your replace clear of combustible
materials, gasoline and other ammable vapor and liquids.
This replace should not be used as a drying rack for
clothing, nor should Christmas stockings or decorations
be hung on or around the replace.
9. Under no circumstances should any solid fuels (wood, coal,
paper or cardboard etc.) be used in this replace.
10. The ow of combustion and ventilation air must not be
obstructed in any way.
11. When the replace is installed directly on carpeting,
vinyl tile or any combustible material other than wood,
the replace must be installed on a metal or wood panel
extending the full width and depth of the replace.
12. This replace requires adequate ventilation and combus-
tion air to operate properly.
13. This replace must not be connected to a chimney ue
serving a separate solid fuel burning replace.
14. When the replace is not in use it is recommended that
the gas control valve be left in the “OFF” position.

Martin DESIGNER Specifications

General

Brand	Martin
Model	DESIGNER
Category	Indoor Fireplace
Language	English