53D0419 9
Figure 3 - Locating Gas
Fireplace
A. WALL LOCATION (See Figure 3)
Y Minimum distance between a glass panel and a parallel wall = 3
1
/2'
Z Minimum distance between the edge of a glass panel and an adjacent wall = 3"
B. Island Location (See Figure 3)
X (Maximum length of horizontal venting = 20'. Refer to the venting section of this manual for specic dimensions.
IMPORTANT:
PLEASE READ THE FOLLOWING CAREFULLY
Remove any plastic from trim parts before turning the replace ON.
It is normal for replaces fabricated of steel to give off some expansion and/or contraction noises during the start up or
cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.
It is not unusual for your Monessen gas replace to give off some odor the rst time it is burned. This is due to the curing
of the paint and any undetected oil from themanufacturing process.
Please ensure that your room is well ventilated — open all windows.
It is recommended that you burn your Monessen replace for a least ten (10) hours the rst time you use it. If the optional
fan kit has been installed, place the fan switch in the “OFF” position during this time.
PRE-INSTALLATION INFORMATION
To Next Page
Loading...
Need help?
General
