2
The following symbols may be used throughout
this manual:
CAUTION. Failure to carefully follow the described
procedure may result in damage to the equipment.
WARNING. Failure to carefully follow the described
procedure may result in damage to the equipment
and/or operator/patient injury.
Risk of electrical shock present.
Ensure power is disconnected before attempting
this procedure.
GENERAL INFORMATION
Denition of Symbols
Product Disposal
Contact your local authorized dealer for proper disposal of the
device to ensure compliance with your local environmental
regulations.
Interference with Electromedical Devices
To guarantee the operational safety of electromedical devices, it
is recommended that the operation of mobile radio telephones
in the medical practice or hospital be prohibited.
Strong EMI sources such as electro surgery units or x-ray units
may affect performance. If performance problems occur, move
the light to another electrical circuit or physical location.
Incompatible Devices and/or Accessories
For reasons of product safety, only original manufacturer
devices & accessories approved for this product, or
accessories from third parties which have been released by the
manufacturer may be used. It is the user’s risk when using non-
released accessories are used.
Obtaining Technical Literature
The manufacturer will make available on request circuit
diagrams, component parts lists, descriptions, calibration
instructions or other information that will assist technical
personnel to repair and replace serviceable items.
Product Identication
This dental light can be identied by its product label, located
on product. This label states the light model and serial
number, electrical specications, manufacture date and safety
classication. Note the SAMPLE labels shown below.
Waste Electrical and Electronic Equipment
Protective Earth (Ground)
Manufacturing date
Type B Equipment
(Protected against electrical shock)
Dangerous Voltage
Electrical Testing Lab
AC (Alternating Current)
CAUTION: Only authorized service
technicians should attempt
to service this equipment.
Use of other than authorized
technicians will void the
warranty.
WARNING: This product must be
disinfected before use.
EN60601-1-2, UL60601-1
Dental Light
Marus
11727 Fruehauf Drive
Charlotte, NC 28273 USA
MN
SN
92162• Rev.5 •02/12
115 VAC, 60HZ, 1.09A
IEC Type B, Class 1, IPX4
Operation Mode: Intermittent
Conforms to:
Certified to:
CAN/CSA - C22.2 NO.601.1
59768
EN60601-1-2, UL60601-1
Dental Light
Marus
11727 Fruehauf Drive
Charlotte, NC 28273 USA
MN
SN
92163 • Rev.5 • 02/12
230 VAC, 50HZ, 0.6A
IEC Type B, Class 1, IPX4
Operation Mode: Intermittent
Conforms to:
Certified to:
CAN/CSA - C22.2 NO.601.1
59768
Authorized European Representative:
Medical Device and QA Services
76, Stockport Road
WA15 7SN
United Kingdom
e-mail: info@mdqa.co.uk
WARNING: This product is intended
for use by trained dental/medical
professionals only.
Identication mark that indicates the product
complies with the health & safety requirements
as published by European Directives.