Why Mase Generators Inverter starts and stops?
Your Mase Generators Inverter might start and stop due to several reasons: * A defective fuel solenoid. * A choked fuel filter. * A defective injector pump. * Intervention of a safety device. * A defective feeding pump.
What to do if Mase Generators Inverter does not start?
If your Mase Generators Inverter does not start, the possible causes include: * Defective starting buttons. * Defective fuel solenoid. * Defective battery cable section. * Defective starting motor. * Choked fuel filter. * 12V circuit fuse issue. * Avv./Ev.relay problem. * Blocked valves.
Why Mase Generators IS 4501 Inverter produces black smoke?
The black smoke from your Mase Generators Inverter could be caused by a defective injector pump.
Why Mase Generators IS 4501 Inverter is running unstable?
Unstable running of your Mase Generators Inverter can be attributed to: * Too much oil in the crankcase. * A defective injector pump. * A defective governor linkage. * Worn valve guides. * Worn cylinder and position rings.
What to do if Mase Generators Inverter emits white smoke?
White smoke from your Mase Generators Inverter could be due to: * Safety device intervention. * Overload. * Defective injector.
Engine specifications including model, displacement, RPM, power, and fuel consumption.
How to identify the generator and engine using serial numbers.
Lists and identifies all major components of the generator.
Details the components of the generator's control panel.
How to check the resistance of the excitation winding.
How to check the resistance of the power winding.
How to check the resistance of the battery charger winding.
Checks for the battery charger fuse and thermal switch.
How to check the resistance of the rotor winding.
Procedures for checking rotor diodes and capacitor.
Checks for the relay board and its fuse (1A).
How to check the relay and 1A 1000V diodes.
How to check the resistance of 6A 600V diodes.
Checks the printed circuit and lists alarm codes with reasons.
How to check and clean the heat exchanger.
Procedures for checking zinc anode and stop solenoid.
How to test the diesel pump and notes on filter replacement.
Checks for water temperature and oil pressure switches.
Checks for high temperature sensor and starter motor.
How to check and adjust the water pump belt tension.
How to check and replace the water pump impeller.
How to verify and adjust engine speed for correct frequency.
General| Brand | Mase Generators |
|---|---|
| Model | IS 4501 |
| Category | Inverter |
| Language | English |
To Next Page
