4
WE RECOMMEND THAT THE INSTALLATION OF YOUR MASPORT SOLID FUEL BURNING
APPLIANCE BE CARRIED OUT BY A QUALIFIED INSTALLATION TECHNICIAN.
LE4000 PROVINCIAL MODEL HAS AIR RECIRCULATING FAN WHICH MUST BE INSTALLED
AND ALL ELECTRICAL WORK BE CARRIED OUT BY A LICENSED ELECTRICIAN. REFER
DETAILED INSTRUCTIONS FOR INSTALLATION OF FAN FOR THIS MODEL ON PAGE 14.
IN SOME REGIONS POWER POINTS ARE NOT PERMISSIBLE WITHIN THE FLOOR
PROTECTOR AREA, PLEASE CHECK WITH YOUR LOCAL AUTHORITY.
IF THE SUPPLY CORD IS DAMAGED, IT MUST BE REPLACED BY THE MANUFACTURER OR
ITS SERVICE AGENT OR A SIMILARY QUALIFIED PERSON IN ORDER TO AVOID
ELECTRICAL HAZARD.
WARNING: THE APPLIANCE AND FLUE SYSTEM MUST BE INSTALLED IN ACCORDANCE
WITH AS/NZS 2918:2001 AND THE APPROPRIATE REQUIREMENTS OF THE REVELANT
BUILDING CODE OR CODES.
WARNING: APPLIANCES INSTALLED IN ACCORDANCE WITH THIS STANDARD MUST
COMPLY WITH THE REQUIREMENTS OF AS/NZS 4013 WHERE REQUIRED BY THE
REGULATORY AUTHORITY, I.E. THE APPLIANCE SHALL BE IDENTIFIABLE BY A
COMPLIANCE PLATE WITH THE MARKING ‘TESTED TO AS/NZS 4013’. ANY MODIFICATION
OF THE APPLIANCE THAT HAS NOT BEEN APPROVED IN WRITING BY THE TESTING
AUTHORITY IS CONSIDERED TO BE IN BREACH OF THE APPROVAL GRANTED FOR
COMPLIANCE WITH AS/NZS 4013.
LE4000 PROVINCIAL APPLIANCES CAN NOT BE FITTED WITH WATER HEATING DEVICE
SUCH AS WATER BOOSTER.
NOTE
The following instructions cover the installation of the model LE4000 Provincial Built-In Fire to be
installed when no conventional masonry chimney is available. The woodfire will need a ‘zero
clearance’ metal shielding box, ‘zero clearance’ fascia with top & bottom ventilated rails and special
‘zero clearance’ flue kit. The installation may be made onto a timber or particle board floor or a
concrete floor. See Special Constructions below for concrete floors.
CAUTION :
• PLEASE ENSURE THAT ONLY COMPONENTS APPROVED BY GLEN DIMPLEX
AUSTRALASIA LTD ARE USED FOR INSTALLATION, as substitutes may adversely affect
performance and might nullify compliance with the requirements of AS/NZS 2918:2001.
• MIXING OF APPLIANCE OR FLUE SYSTEM COMPONENTS FROM DIFFERENT
SOURCES OR MODIFYING THE DIMENSIONAL SPECIFICATION OF COMPONENTS
MAY RESULT IN HAZARDOUS CONDITIONS. WHERE SUCH ACTION IS CONSIDERED,
THE MANUFACTURER SHOULD BE CONSULTED IN THE FIRST INSTANCE.
• CRACKED OR BROKEN COMPONENTS, E.G. GLASS PANELS, MAY RENDER THE
INSTALLATION UNSAFE.
• USE SMOKE DETECTORS ARE REQUIRED TO BE FITTED IN ALL RESIDENTIAL
HOUSEHOLDS AS PER THE GUIDELINES GIVEN IN AS1670.6 OR MANUFACTURER OF
THE SMOKE ALARM OR LOCAL BUILDING AUTHORITY.
• KEEP FURNITURE AND DRAPES WELL AWAY FROM THE STOVE.
To Next Page
Loading...
Need help?
General
