14
ELECTRICAL INSTALLATION
ALL ELECTRICAL WORK MUST BE CARRIED OUT BY A LICENCED REGISTERED
ELECTRICIAN.
THE FAN IS TO BE PERMANENTLY CONNECTED TO THE MAINS SUPPLY WITH NO
PERIPHERAL CONTROLS. THIS MEANS, THERE MUST NOT BE A PLUG AND SOCKET
ARRANGEMENT. IN ORDER TO COMPLY WITH THE NEW ZEALAND ELECTRICAL
STANDARDS, AN ISOLATION SWITCH IS NEEDED FOR ISOLATING THE FAN FROM THE
SOURCE OF POWER.
FOR FIRES INSTALLED IN THE CANTERBURRY REGION:
A COMPLIANCE CERTIFICATE, SIGNED BY THE PERSON RESPONSIBLE FOR WIRING THE
APPLIANCE, SHALL BE SUBMITTED TO THE CANTERBURY REGIONAL COUNCIL, WITHIN
ONE MONTH OF INSTALLATION, TO CERTIFY THAT THE SYSTEM IS WIRED IN
ACCORDANCE WITH THE MANUFACTURER’S SPECIFICATIONS AND INSTRUCTION GIVEN
IN THIS MANUAL.
OPERATIONS OF FAN
During the operation of the fire, once the fire has warmed up, the internally mounted heat operated
switch (Thermodisc) will automatically switch the fan on. It may take approximately 15 minutes to
reach the switching temperature. This is to prevent cold air being circulated. The fan will be
running throughout the heating cycle. This is to ensure maximum efficiency for your woodfire.
Once the fire has cooled down, the fan will automatically switch off. The fan uses very little power,
approximately 30 Watts.
SAFETY
The appliance is not intended for use by young children or infirm person without
supervision. Supervise young children to ensure they do not play with the appliance.
If a supply cord is damaged, it must be replaced by the manufacturer, it’s service agent or a
suitably qualified person, in order to avoid electrical hazard.
MAINTENANCE
The fan should need little attention other than occasionally (perhaps once a year) removing it to
clean dust and lint from the impeller. First using isolation switch , isolate the appliance from the
electricity source. The fan can be accessed by removing the ash shelf. This is done by turning the
two screws below the ash shelf
1/4 turn and pull the bottom of the shelf out and then lift the shelf up
to disengage the top. Clean the impeller blades carefully by blowing or vacuuming. Do not apply
force to the impellers. Reinstall the ash shelf. Switch ON the power supply using isolation switch.
To Next Page
Loading...
Need help?
General
