Massey Ferguson 6400 - Issue 4.a
2B11.7
Perkins/GTA2520 engine separation
Preparing for disassembly
18. Stop the front axle swinging (all versions) by sliding
a suitable chock in at each side of the support (1)
(Fig. 7).
19. Chock the rear wheels.
20. Install (Fig. 8):
- a fixed stand at the front of the gearbox
- a mobile stand at the rear of the engine
21. If necessary, separate the cab from the front right-
and left-hand supports. Gently lift it using two
straps fitted to the lateral handles. Temporarily
place a wooden chock between the cab and the
supports.
Fig. 6
Fig. 7
To Next Page
Loading...