MASSEY FERGUSON 6445 - Page 167

Massey Ferguson 6400 - Issue 4.a
2B21.11
Splitting the Sisu engine/GTA1030
Final operations
Final operations are not especially difficult. They there-
fore will be carried out in the reverse order of the
preliminary operations.
However, the following operations need to be
performed during refitting:
- if necessary, tighten the cab front silent block
screws at the require tightening torque (see
chapter 12);
- top up the level of coolant, to the maximum level
marked on the expansion tank (Fig. 14);
- test:
- the air conditioning system (if fitted - see
chapter 12);
- the suspended front axle (if fitted, see chapter 8),
- all mechanical, hydraulic, electrical and electronic
functions concerned by servicing;
- check the tightness:
- of the hydraulic unions,
- of water hoses,
- of the bleed screw on control unit of suspended
front axle (if fitted).
M
A
X
M
I
N
MA-02-05124A
Fig. 14
¤
H