MASSEY FERGUSON 6445 - Page 182

Massey Ferguson 6400 - Issue 1
02C01.14
Splitting - GBA20 gearbox / Centre housing
Reassembling
69. Clean the mating surfaces of the gearbox and the
centre housing.
On the centre housing
70. Check the presence of locating pins (4) (Fig. 16).
Remark
The pins are “force” fitted.
71. Position the spring (1) in the PTO clutch. (Fig. 17).
72. Smear the mating face of the centre housing with
Loctite 5206 or equivalent, avoiding the hare and
tortoise ports.
73. Replace the O'rings (2) (Fig. 17).
74. Screw two diametrically opposed guide studs into
the centre housing.
Fig. 16
Fig. 17
¤
H