MASSEY FERGUSON 6465 - Page 146

Massey Ferguson 6400 - Issue 4.a
2B11.22
Perkins/GTA2520 engine separation
Final steps
Note
Final steps are not especially difficult.
They should be carried out in the reverse order to
preliminary steps. However, it will be necessary during
reassembly to carry out the tightening torques,
adjustments and tests described below.
Tightening torques
As required:
- front cab screws (see chapter 12)
- screw (2) of the connector (1) on the main harness
(Perkins EEM engine) (Fig. 19 and Fig. 26) to a
torque of 2.82–3.15 Nm.
Topping-up
- of coolant to the maximum level marked on the
radiator and expansion tank (Fig. 27).
Tests
- air conditioning system (if fitted—see chapter 12)
- cab suspension (if fitted—see chapter 12)
- all mechanical, hydraulic, electrical and electronic
functions subject to operations
Checking tightness
- of hydraulic unions
Fig. 26
Fig. 27
¤
H