Oil and Filter Change
9. Install the new oil filter cartridge with an oil filter wrench ,and then tighten it to the specifiec torque
with a torque wrench .Oil filter cartridge tightening torque:17N·m (17m·kgf,12ft·lbf).
10. Reinstall the sealing washer on the drain plug
11. Reinstall the drain plug.Add the recommended engine oil.
12. Place the transmission in PARK.Apply the brakes.
13. Start the engine.Allow it to idle for one to two minutes.
14. Stop the engine.Inspect for leaks.
15. Re-check the oil level on the dipstick and add oil as necessary to bring the level to the upper mark
on the dipstick.
16. Dispose of used filter and oil properly.
To Next Page
Loading...
