MAINTENANCE
Battery
CAUTION:A special battery charger (constant voltage/ampere or constant voltage) is required for
recharging a sealed type battery. using a conventional battery charger may shorten the
battery life.
Fuse replacement
1.The fuses are under the meter cover.
2. If a fuse is blown, turn off the main switch and the switch of the circuit in question. then, install a
new fuse of the specified amperage. Turn on the main switch. If the fuse immediately blows again,
consult your dealer.
Specified fuses:
Battery fuse: 30A Cigarett light fuse:15A Fuel pump fuse:10A
Fan fuse: 10A Winch/dump pump fuse:10A High beam fuse:10A
Brake light Fuse: 10A Turning light fuse:5A Low beam fuse:10A
Light power fuse: 15A Horn fuse:5A Wiper fuse:15A
Ignition fuse:10A 2/4 WD fuse:5A MP3 fuse:5A
To Next Page
Loading...
