1.General and safety details
Congratulations on your purchase of an eMOTION XLS Sound Decoder. The eMOTION XLS Sound Decoder is
an exceptional, high-performance Digital Decoder designed for G-Scale by Massoth Electronik GmbH,
Germany. We highly recommend reading this manual and the documentation carefully and thoroughly before
operating your eMOTION XLS Sound Decoder.
Massoth Electronik GmbH used the latest in technology in designing and manufacturing the eMOTION XLS
Sound Decoder. Excellent operation at all times is assured by the high safety standard in data processing and
by delivering an exceptional power output and performance. Future alterations in the DCC standards are easily
implemented in the eMOTION XLS Sound Decoder by updating. The latest Flash-Technology is utilized in the
eMOTION XLS Sound Decoder to provide a safe and consumer-friendly operation during updating.
1.1.Layout of Terminals
1 x eMOTION XLS Decoder
1 x Manual
1 x Speaker
1 x Interface-cable for LGB
1 x Interface-cable for ARISTOCRAFT DCC
2 x Screws
2.Important information for the operation.
Install your decoder in compliance with the connecting diagram in this manual. The decoder is protected
against shorts and excessive loads. However, in case of a connection error e.g. a short between a light and the
motor, this safety feature cannot work and the decoder will be destroyed subsequently.
The decoder is originally programmed on address #3 with 14 speed steps. In case you want to use a high
address, you have to program CV17, CV18, and CV29 accordingly. If you want to use 28 speed steps you need
to set CV29-Bit1 to ”2”. Otherwise the lights might not work or may flicker.
Properties of the eMOTION XLS Sound Decoder
Decoder functions:
• Loco decoder for digital and analog operation
• Motor output max. 3 Amps (or 2 motors with 1.5 Amps each)
• 3 light outputs with 300 mAmps each (front, rear, interior)
• 8 function outputs 4 with 600 mAmps each (F1-4), 4 with 10 mAmps each (F5-8)
• Overload and excess temperature protection for motor and functions
• Hookup utilizing 18 C-clamps
• Easy installation with 2 plastic brackets and screws
Sound functions:
• 6 channel play-back (6 sounds at the same time)
• 1 Watt amplifier for 8 Ohms loudspeaker
• Memory capacity for max. 200 sec of recorded sound
• 4 driving sounds and 12 side noises selectable
• Play-back frequency 10 kHz – 16 kHz
• Pulse generator interface for synchronization and reed switch terminal for manual function triggering
• Volume control by potentiometer or CV programming (also individual Sounds)
• Sound functions usable in analog mode
• Sounds and software changeable
eMOTION XLS Sound Decoder 4
To Next Page
Loading...
