REPLACING THE BATTERY
WARNING
Before attempting to open the case of battery, always be sure that
test leads have been disconnected from measurement circuits.
Close case and tighten screws completely before using the meter
to avoid electrical shock hazard.
If “ ”appears on display, it indicates that the battery should be
replaced. Use the following procedure to replacing the battery:
1. Disconnect test leads from any live source and remove the test
leads from the input terminals of the meter. Push the POWER
switch to OFF,
2. The battery cover is secured to the bottom case by a screw.
Using a screwdriver, remove the screw from the battery cover
and remove the battery cover.
3. Remove battery and replace with a new equivalent 9 volt
battery.
4. Replace the battery cover and reinstall the screw.
ACCESSORIES
• Operator’s instruction manual
• Set of test leads
• Gift box
• 9 volt battery. NEDA 1604 6F22 006P type.
-10-
To Next Page
Loading...
Need help?
General
