Mastech MS2001 - Safety Information and Precautions; Safety Symbols

SAFETY INFORMATION
The digital clamp meter has been designed according to IEC1010–
1 and IEC1010–2–032 concerning safety requirements for
electrical measuring instruments and hand – held current clamps
with overvoltage category 1000V CAT II 600V CAT III and pollution
2.
SAFETY SYMBOLS
Important safety information, refer to the operating manual.
Dangerous voltage may be present.
Earth ground.
Double insulation ( Protection class 1000V CAT II 600V
CAT III ).
The digital clamp meter complies with the requirements of the
following European Community Directives: 89/336/EEC ( Elec-
tromagnetic Compatibility ) and 73/23/EEC ( Low Voltage ) as
amended by 93/68/EEC ( CE Marking ).
However, electrical noise or intense electromagnetic fields in the
vicinity of the equipment may disturb the measurement circuit.
Measuring instruments will also respond to unwanted signals that
may be present within the measurement circuit.
Users should exercise care and take appropriate precautions to
avoid misleading
-1-