The circuit of the measured resistance exceeds the lower limit,
The number of save groups is 8 and the current time is 12:08
4. Clock Settings
After power on, long press the "SET" button (more than 3
seconds) to enter the clock setting mode. When the time data
flashes, it is in the modified state. Press the "AL" button or the
"MEM" button to increase or decrease the corresponding data.
Short press the "MODE" button to switch. To modify the data, press
the "SET" button again to save and exit.
5. Alarm Settings
After power on, short press "AL" key to turn on or off the alarm function,
long press "AL" key to set the resistance alarm value, press the "SET" key
and "MEM" key to change the current size, short press "MODE" key to
switch Alarm mode, long press "AL" key to save and exit. When the
measured resistance is greater than the alarm critical setting and the alarm
is turned on, the meter flashes the “ ” symbol and issues a “beep-
beep-beep--” alarm sound. The maximum value of the ground resistance
alarm setting is 200Ω. As shown below:
6. Date Lock
After the measurement is stable after power on, short press “HOLD”
To Next Page
Loading...
