2. Determine whether the transistor to be tested is NPN or PNP, and locate the E, B and C leads.
Insert the leads of the transistor into their proper holes of the transistor testing socket.
3. The meter will show the approx. hFE value at the test condition of Ib≈10μA and Vce≈
3.2V.
CONTINUITY TEST
1. Connect the black test lead to the “COM” jack and the red test lead to the “VΩHz” jack.
2. Set the rotary switch to “ ” range and connect the test leads to the two terminals of the
circuit to be tested. If the resistance is less than about 70Ω, the built-in buzzer will sound.
Battery & Fuse Replacement
If “ ” appears on the LCD, it indicates that the battery should be replaced. To replace the
battery, open the case and replace the exhausted battery with the ratings specified: 9V, NEDA
1604 or 6F22.
The fuse rarely needs to be replaced and is blown as a result of the operator’s error. To replace the
fuse, open the case and replace the blown fuse with the ratings specified: F 250mA/250V.
To replace battery or fuse, remove the 2 screws in the bottom of the case and open the case.
Replace the battery or fuse with a new one of the same rating. Close case and tighten screws
completely.
ACCESSORIES
Users Manual 1 copy
Test Leads 1 pair
9V Battery (NEDA 1604 or 6FF22) 1 piece
To Previous Page
Loading...
