test.
※ When carrying out measurements on TV or
switching power circuits, always remember that there
may be high amplitude voltages pulses at test points
which can damage the meter.
※ Never perform resistance measurements on live
circuits.
※ Always be careful when working with voltages
above 60V dc or 30V ac rms. Keep fingers behind the
probe barriers while measuring.
1.3 SYMBOLS
Important safety information, refer to the operating
Dangerous voltage may be present.
Double insulation (Protection class Ⅱ)
1.4 MAINTENANCE
Before opening the meter, always disconnect test ※
leads from all sources of electric current.
For continue protection against fire, replace fuse ※
only with the specified voltage and current ratings: F1:
2A/250V F2: 10A/250V
If any faults or abnormalities are observed, the ※
meter can not be used any more and it has to be
- 2 -
To Next Page
Loading...
Need help?
General
