1. SAFETY INFORMATION
This multimeter has been designed according to
IEC-1010 concerning electronic measuring instruments
with an overvoltage category ( CATⅡ) and pollution 2.
Follow all safety and operating instructions to ensure
that the meter is used safely and is kept in good
operating condition.
1.1 PRELIMINARY
※ When using this meter, the user must observe all
normal safety rules concerning:
— Protection against the dangers of electrical current.
— Protection of the meter against misuse.
※ Full compliance with safety standards can be
guaranteed only if used with test leads supplied. If
necessary, they must be replaced with the same model or
same electronic ratings. Measuring leads must be in
good condition.
1.2 DURING USE
※ Never exceed the protection limit values indicated in
specifications for each range of measurement.
※ When the meter is linked to measurement circuit, do
not touch unused terminals.
※ When the value scale to be measured is unknown
beforehand, set the range selector at the highest
position.
※ Before rotating the range selector to change
functions, disconnect test leads from the circuit under
- 1 -
To Next Page
Loading...
Need help?
General
