Master Bilt Master Controller 2.0 User Manual

2
IMPORTANT NOTICES
• Read this manual before installing your Master Controller 2.0
system. Keep the manual and refer to it before doing any service on
the equipment. Failure to do so may result in personal injury or
waive warranty of damaged equipment.
• Modifications to existing equipment are subject to approval by Master-
Bilt and must be explicitly written. There are no implied flexibilities
designed into this product.
• The following points apply unless overwritten and approved by the
Master-Bilt engineering department:
o Maximum distance of wires between the evaporator and the
Master Controller 2.0 MUST not exceed 40 ft.
o The Master Controller 2.0 MUST be mounted on the
neighborhood of the vestibule entrance door for below -40
o
F extra
low temp freezer
o All sensor wires MUST be in separate metal conduit from power
wiring and control wiring for below -40
o
F extra low temp freezer
• Due to continuous product enhancements, Master-Bilt reserves the right
to make engineering changes and change specifications for product
improvement without notice.

Master Bilt Master Controller 2.0 Specifications

General

Brand	Master Bilt
Model	Master Controller 2.0
Category	Controller
Language	English