Master-force 260-9508 - Specifications; Replacement Parts

Page 17
PROBLEM POSSIBLE CAUSE SOLUTION
The charger
will not turn on
when properly
connected.
AC outlet is dead.
Poor electrical
connection.
Bad battery.
Check for open fuse
or circuit breaker
supplying AC outlet.
Check power cord
and extension cord
for loose fitting plug.
Have battery
checked.
I cannot select
a 6V or 12V
setting.
The charger is equipped
with Auto Voltage
Detection, which
automatically detects the
voltage and charges the
battery.
No problem; this is
normal.
14. SPECIFICATIONS
Input voltage .................................................................120 V AC
Input frequency ...................................................................60 Hz
Input current .........................................................................0.4 A
Output voltage ........................................................... 6 V or 12 V
Output current ................................1.5 A/6 V DC; 1.5 A/12 V DC
15. REPLACEMENT PARTS
Mounting bracket (with nuts and bolts) ................2299000544Z