8. Flip assembly upright. Place drip tray
assembly (E) onto the left drip tray rail (O) and
right drip tray rail (T). Then, slide the grease
cup (F) into the slot on the underside of the
drip tray assembly (E).
7. Carefully flip the assembly upside down.
Using the wrench provided in the pack of
unlockable casters (Z), install the unlockable
casters (Z) to the front legs of the assembly.
Then, install the lockable casters (W) to the
rear legs of the assembly.
9.1. Remove the preassembled M6 x 20
screws, spring washers, flat gaskets and lid
handle bezels (D) from lid handle (C). Then,
attach lid handle (C) to lid assembly (A) where
shown with the flat gaskets, spring washers
and M6 x 20 mm screws on the inside.
9.2. Remove the preassembled flat gasket
and wing nut from the temperature gauge (B).
Then, attach temperature gauge (B) to lid
assembly (A) where shown using the flat
gasket and wing nut on the inside.
9.3. Insert knobs (J) where shown on lid
assembly (A) by simply pressing them into
each valve.
To Next Page
Loading...
Need help?
General
