Master Forge CBC23043L - Page 9

9
7
T
V
ASSEMBLY INSTRUCTIONS
1 2
Step 7: Attach Leg Connector and Front Leg
Connect the front legs (T) with the leg connector (V).
Align the holes in the other front legs (T) and bottom
bowl (G). And then attach it onto the bottom bowl (G)
with two M6x12 screws (CC), Ø6 washers (FF) and
M6 nuts (KK).
Attach the bottom mesh (W) onto the other front leg
(T) with one M10 nut (LL).
Hardware Used
Step 8: Attach Ash Receiver Slide
Align the holes in the ash receiver slide (O) and
bottom bowl (G). And then attach it onto the
bottom bowl (G) with four M5x8 screws (AA) and
Ø5 washers (EE).
Hardware Used
8
3
4
T
G
W
M6x12
Screw
CC
x 2
Ø6
Washer
FF
x 2
M6
nut
KK
x 2
M10
Nut
LL
x 1
M5x8
Screw
AA
x 4
Ø5
Washer
EE
x 4
G
O