15
LIGHTING THE GRILL
Before first use:
Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important
WRFOHDQ\RXUJULOOZLWKKHDW7RGRWKLVRSHUDWHWKHJULOOIRUDSSUR[LPDWHO\PLQXWHVZLWKWKHOLGFORVHG
and the control knob in the highest position. This will clean the internal parts by burning off any residue
and odor from the manufacturing process.
OPERATION INSTRUCTIONS
If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF
the cylinder valve and then TURN OFF the control knob.
CAUTION
WARNING
1. Check that the control knobs are in the OFF position.
2. Open valve at tank fully by turning counter-clockwise.
3. Open lid during lighting.
4. Push igniter down 3 to 4 seconds while turning right side control knob to the HIGH position. The
burner should ignite.
If ignition does not take place within 5 seconds, immediately turn the control knob to the OFF
position. Wait 5 minutes and repeat step 4 above or refer to match lighting instructions below.
5. Repeat step 4 above to ignite left side burner.
If the burner still does not light, check that there is gas in the cylinder and follow the match lighting
instructions.
LIGHTING THE GRILL WITH A MATCH
Do not lean over grill when lighting. Read instructions before lighting.
1. Insert a match in the end of the match holder that is installed on the inside of the cabinet door.
2. Light the match.
3. Immediately place the lit match through the 20mm (0.75 in.) hole on the side of the grill body,
nearest the left burner. Make sure the lit match is close to the burner ports.
4. Press in the control knob that operates the left burner and rotate counter-clockwise to High
position and burner should light immediately.
5. The other main control can now be turned on the High position and will light via crossover port.
6. Adjust burners to desired cooking settings.
SHUTDOWN INSTRUCTIONS
1. Turn control knobs clockwise to the OFF position.
2. Close valve at tank fully by turning clockwise.
3. Close lid.
Turn off LP supply at cylinder when appliance is not in use.