Master Water Conditioning SIMPLUS 744 - General Troubleshooting; Rotten Egg Odor Issues; Regeneration Failures; No Chlorine Draw Problems

10
Troubleshooting
Problem: Rotten egg odor returns
Possible Cause
Solution
Media bed may be fouled
Add 1 qt. of chlorox bleach and
manually regenerate unit
Problem: Water conditioner fails to regenerate. No treated water.
Possible Cause
Solution
Faulty electrical supply
Verify that electrical power is getting to
the outlet
Low inlet water pressure
Verify a minimum 30 psi inlet water
pressure
Drain line restriction
Insure that the drain line is free of
blockage
Defective timer motor
Replace timer motor
Manual bypass valve is open.
Close manual bypass valve.
Leak at riser pipe seal.
Insure that riser pipe is properly sealed
at o’ring seal. Inspect pipe for cracks.
Plugged injector or injector screen.
Inspect and clean injector and/or
injector screen.
Incorrect P Value Programming
Reprogram with proper P Value—
See Insert Sheet.
Problem: No Chlorine Draw
Possible Cause
Solution
Plugged injector or injector screen.
Inspect and clean injector and/or
injector screen.
Insufficient water pressure.
Verify a minimum 30 psi inlet water
pressure
Obstructed drain line.
Remove obstruction.