11
ARMADO
PASO 11
Alinee los orifi cios guía del defl ector
de residuos (5) con los pasadores
del interior del cuerpo del ahumador.
Presione el defl ector de residuos
hacia abajo para fi jarlo en su lugar.
5
PASO 12
Coloque el recipiente para el agua (8),
la bandeja paara trocitos de madera (9)
y el colector de residuos (10) dentro
del ahumador, como se ilustra.
Introduzca el cargador de trocitos
de madera (12) en el costado del
ahumador.
Ya ha terminado el armado.
8
9
10
12
8
ASSEMBLY
STEP 6
Carefully position smoker as
shown.
Attach rear handle (3) to back of
smoker body (1) using phillips
screws (A) as shown.
Note: Do not lift unit by rear handle.
STEP 5
Insert adjustable screw leg (11)
through bottom of side panel (23)
as shown, and into smoker body.
Repeat step on opposite side for
remaining adjustable screw leg.
Note: When unit is upright, set
adjustable screw leg height by
turning clockwise/counterclock-
wise, so that smoker is level.
Once level, secure leg positions
by tightening tension nuts.
1
TENSION NUT
23
A
3
11
To Next Page
Loading...
Need help?
General
