EasyManuals Logo

Masterbuilt GRAVITY Series User Manual

Masterbuilt GRAVITY Series
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
33
Operating Instructions
ASSEMBLY IS DONE. LET’S HAVE SOME FUN!
START-UP
1. REMOVE heat intake and air intake slides. (Refer to assembly step 21.)
2. Open hopper lid and hopper ash door.
There is a safety switch at each of these doors that will prevent the fan from running when these doors are opened.
If charcoal remains from a previous cook, shake the charcoal grate to ensure all ash falls through to the ash tray.
Discard any ash from the ash tray.
3. Fill hopper with charcoal.
Approximately 16 lbs. of charcoal briquettes.
Approximately 10 lbs. of lump charcoal.
Never use fast light charcoal or lighting fluid.
If charcoal slips through charcoal grate into ash can, remove before starting.
4. Place fire starter in charcoal grate and light.
Use a food safe fire starter block or twisted paper towel/paper.
Place in charcoal grate on the fire starter support bars.
Use caution and wear protective gloves.
Light with match stick or lighter.
5. Turn on controller and set to desired temperature.
Wait 1–2 minutes after lighting fire starter to ensure fire starter is fully lit.
6. Close hopper lid and ash door.
This will activate the fan.
7. Wait for grill to reach desired set temperature.
Approximately 13 minutes to reach 700°F (370°C).
Approximately 7 minutes to reach 225°F (105°C).
PRE-SEASONING
Pre-seasoning will rid your grill of chemicals and oils left over by the manufacturing process, allowing them to burn
off. PRE-SEASON GRILL PRIOR TO FIRST USE.
1. Fill the hopper with charcoal approximately 1/4–1/2 full.
2. Start grill following the START-UP instructions and set the temperature to 250°F (121°C)
for 60 minutes.
3. Set the temperature to 400°F (204°C) for 30 minutes.
4. Shut down the grill following the SHUTDOWN instructions.
5. Allow grill to cool COMPLETELY.
6. Using a napkin or cloth, rub a light coat of cooking oil on smoke + sear grates, warming/smoking racks, charcoal
grate and the inside of the grill lid and body.
7. Repeat steps 3–6 at 350°F
Note: Fire starter will be
placed here.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Masterbuilt GRAVITY Series and is the answer not in the manual?

Masterbuilt GRAVITY Series Specifications

General IconGeneral
WiFi and Bluetooth ConnectivityYes
Built-in Temperature GaugeYes
Fuel TypeCharcoal
Cooking Area1050 sq in
Control TypeDigital
Temperature ControlDigital
Hopper Capacity10 lbs
ConstructionSteel

Related product manuals