REGULATING TEMPERATURE
IN YOUR GRILL:
Power ON/Off Controller:
1. Rotate control knob clockwise to power controller ON
and set temperature (the thermostat inside the grill
body controls the fan ON/OFF automatically).
2. Rotate control knob counter clockwise to power controller OFF
and lower temperatures.
Operating Instructions
CONTROL PANEL
CLEANING AND STORAGE
ALWAYS MAKE SURE GRILL IS COOL TO THE TOUCH BEFORE CLEANING AND STORING.
• Once ashes have completely cooled, empty the charcoal hopper of ash after each use. This will help
prolong the life of the charcoal hopper.
• Dispose of cold ashes by placing them in aluminum foil, soaking with water and discarding in a
non-combustible container.
• Remove the charcoal grate and clean.
• Remove the cooking grates and manifold to clean.
• Remove grease cup. Empty and clean (See Figure 1).
• Inspect hardware and assembled parts on a regular basis to ensure grill is in safe working condition.
• Clean grill and cooking grates with mild dish detergent. Wipe outside of grill with a damp rag. DO NOT
use oven cleaner or other cleaning agents. Make sure to dry thoroughly.
• Wipe down with cooking oil to avoid rusting
• Always cover and store grill in a protected DRY AREA. Store only when fire is out and all surfaces are cold.
• When grill is not in frequent use, even when using a grill cover, remember to check your grill periodically
to avoid possible rust and corrosion due to moisture buildup.
13
Set Temperature (
250-550F / 121-288C)
:
1. Pour charcoal over lit fire starter
2. Wait approximatley 1 minute to allow charcoal to start smoking.
3. Turn to desired setting and let charcoal burn for 4 minutes.
4. Close the hopper lid.
5. Close grill lid and set the vent 3/4 closed.
Your grill has a temp probe located
under the cooking grate that will
regulate the grill temp based on the
position of the control knob.
Knob positon in relation to the grill
temperature will vary based on
outside temperature, amount of food
and charcoal type used.
Once the grill reaches temp based
on the knob position the fan will turn
off. Once the temp falls below temp
setting the fan will turn on and
continue the cycle to maintain a
stable temperature.
The easiest way to find grill
temperature setting is to turn the
grill to high and once the desired
temeprature is reached turn the
knob back down until the fan turns
off, the grill will then maintain that
temperature. You will need to check
this setting again after loading food
and adjust accordingly but after this
the grill will hold temp by itself.
Figure 1
GREASE CUP
To Next Page
Loading...
Need help?
General
