21
Operating Instructions
To use meat probe:
• Insert meat probe into center of meat to get most accurate reading.
• Press the UP or DOWN arrows to stop LED flashing sequence at MP 1. LED will display the internal
temperature at meat probe.
• Press the UP or DOWN arrows again to return display to temperature/meat probe/time remaining
sequence.
Door switch :
• Your smoker is equipped with a door switch that works in correspondence with Bluetooth.
• If the door is opened during the cook cycle the Bluetooth app will switch to “monitor only” and will not
allow you to operate the smoker with your smart device. To enable Bluetooth functionality again, press the
Bluetooth button on the control panel.
To RESET control panel:
If the control panel displays an error message, turn smoker off and unplug smoker from outlet. Wait
ten seconds, plug smoker back into outlet, then turn electric smoker on. This will reset control panel.
To Next Page
Loading...
Need help?
General
