20V max* LITHIUM-ION CORDLESS CIRCULAR SAW - 054-8332-4
18
OPERATING INSTRUCTIONS
WARNING!
Always securely clamp and support the workpiece. Always maintain proper control of the
saw. Failure to clamp and support the workpiece and loss of control of the saw could result in
serious injury.
WARNING!
Do not bind the blade in the cut. It could cause the saw to “kickback” towards you, which
could result in serious injury.
Integrated crosscut rulers
Marked along the base across the front of the saw is a ruler for measuring repetitive cuts. It is marked
1-1/2 inches to the left of 0° and 4 inches to the right of 0° in 1/16-inch increments.
NOTE:
The distance from the line of cut to the guideline is the amount you should offset the guide.
Cross cutting
(g 10)
Maintain proper control of the saw. Loss of control could cause an accident resulting in serious injury.
DANGER!
When lifting the saw from the workpiece, the blade is exposed on the underside of the saw
until the lower blade guard closes. Make sure that the lower blade guard is closed before
setting the saw down.
fig 10