Need help?Do you have a question about the MasterCraft 054-8363-0 and is the answer not in the manual?
General| Model | 054-8363-0 |
|---|---|
| Category | Saw |
| Type | Circular Saw |
| Amperage | 13 A |
| Corded/Cordless | Corded |
| Blade Size | 7-1/4 inches |
| Blade Diameter | 7-1/4 inches |
| No Load Speed | 5500 RPM |
| Motor | 13 Amp |
| Bevel Capacity | 56° |
| Depth of Cut at 90 degrees | 2-7/16 in |
| Depth of Cut at 45 degrees | 1-3/4 inches |
General rules and warnings for safe operation of power tools, including understanding symbols and tool functions.
Emphasizes reading the manual and labels for safe operation and future reference.
General safety warnings and instructions for power tool usage and future reference.
Guidelines for maintaining a clean, well-lit work area and keeping bystanders away.
Precautions regarding power tool plugs, cords, and protection against electric shock.
Advice on staying alert, using protective equipment, and preventing accidental starts.
Instructions on proper usage, maintenance checks, and safe storage of power tools.
Recommendation for qualified service technicians and use of identical replacement parts.
Specific safety advice for operating saws, including blade depth and workpiece support.
Explanation of kickback causes and precautions to avoid it during sawing operations.
Guidance on checking and operating the lower blade guard for safety.
Further safety advice for circular saws, including hand placement and protective gear.
Details on the integrated LED worklight and its functionality.
Information on the proper function and maintenance of the lower blade guard system.
Advice on selecting, maintaining, and using saw blades for efficient and safe cutting.
Explanation of kickback and how to avoid dangerous practices that can cause it.
Directions and best practices to minimize the risk of kickback during operation.
Description of the rulers integrated into the saw base for measuring repetitive cuts.
Instructions on how to properly set the blade depth for various cuts.
Guidance on adjusting the saw's bevel angle for angled cuts.
Procedure for checking the accuracy of the saw's 0° bevel setting.
Instructions on how to adjust the saw's 0° bevel stop for precise square cuts.
Step-by-step guide for safely replacing the circular saw blade.
How to safely turn the circular saw on and off using the trigger switch.
Fundamental methods and considerations for operating the circular saw correctly.
Instructions for attaching and using the edge guide for rip cuts.
Guidance on performing accurate cross cuts and rip cuts.
Specific steps for making rip cuts using a straight edge.
Procedure for setting up and executing a bevel cut with the circular saw.
Details on limitations to the warranty coverage and liability.
Information on consumer legal rights and statutory warranties.
To Next Page