headline bars
continuation tabs
notes
warnings
model no. 054-8363-0 | contact us 1.800.689.9928
27
26
TROUBLESHOOTING
Problem Possible Causes Solution
The motor does not start
The tool is not connected to a power
source
Connect the tool to a power
source
The blade does not follow a
straight line
1. Teeth are dull. This is caused by hitting
a hard object such as a nail, dulling
teeth on one side. The blade tends to
cut to the side with the sharpest teeth.
1. Replace with a new sharp
blade
2. Edge guide or straight edge is not
being used.
2. Use an edge guide or
straight edge
The blade binds or smokes
from friction
1. Blade is dull.
1. Replace with a new sharp
blade
2. Blade is on backwards. 2. Install the blade correctly
3. Blade is bent. 3. Replace with a new blade
4. Workpiece is not properly supported.
4. Clamp the workpiece
correctly and tightly
5. Incorrect blade is being used. 5. Use the correct blade
If any parts are missing or damaged, or if you have any questions, please call the Toll-free Helpline,
at 1-800-689-9928.
EXPLODED VIEW
TROUBLESHOOTING
PART LIST
To Next Page
Loading...
Need help?
General
