Need help?Do you have a question about the MasterCraft 054-8153-0 and is the answer not in the manual?
General| Model | 054-8153-0 |
|---|---|
| Category | Saw |
| Type | Circular Saw |
| Blade Size | 7-1/4 inches |
| Blade Diameter | 7-1/4 inches |
| Cord Length | 6 feet |
| Amperage | 15 A |
| No Load Speed | 5, 500 RPM |
| Depth of Cut at 90 degrees | 2-7/16 inches |
| Depth of Cut at 45 degrees | 1-3/4 in |
| Bevel Capacity | 56 degrees |
Read the instruction manual and labels before operating the tool for correct usage and future reference.
Read all safety warnings and instructions to prevent electric shock, fire, and serious injury.
Minimize risk of electric shock by avoiding contact with grounded surfaces like pipes or radiators.
For outdoor operation, use an extension cord rated for outdoor use to reduce electric shock risk.
Utilize a ground-fault circuit interrupter (GFCI) for protection in unavoidable damp locations.
Operate the tool with alertness, avoiding fatigue and substances that impair judgment.
Always wear eye protection and other appropriate PPE to reduce the risk of personal injuries.
Ensure the switch is OFF before connecting to power or picking up the tool to avoid accidental starts.
Avoid loose clothing, jewelry, and tie back long hair to prevent entanglement with moving parts.
Use the correct power tool for the application; it performs better and safer when used as designed.
Regularly check for damage, misalignment, or binding; have damaged tools repaired before use.
Sharp, clean cutting tools reduce binding and improve control, making them easier to use.
Power tool servicing should only be performed by qualified personnel using identical replacement parts.
Grip insulated surfaces when cutting accessory may contact hidden wiring or the power cord.
Use clamps or other methods to support the workpiece for stability and control.
Avoid using dull or bent blades as they can break easily or cause kickback.
Allow the blade to reach full speed before cutting to prevent chatter, vibration, or kickback.
Keep hands clear of the cutting path; do not reach under material being cut as blade position is hidden.
Use ear protection to prevent potential hearing loss from prolonged exposure to noise.
Illustration showing numbered parts of the reciprocating saw with a corresponding list.
Illuminates the workpiece when the saw is on, providing light in low-light conditions.
Trigger switch controls speed; higher pressure equals higher speed, lower pressure equals lower speed.
Steps to safely install a saw blade using the tool-less blade clamp mechanism.
Procedure for safely removing the saw blade from the tool-less blade clamp.
Adjust the base assembly to modify effective stroke length for control and blade life.
Pivot the shoe to achieve maximum control against the surface being cut.
Connect to power, depress trigger to turn ON, release trigger to turn OFF.
Guidelines for clamping workpiece, selecting blades, adjusting shoe, and cutting technique.
Instructions for plunge cutting into surfaces like walls or floors, with blade insertion methods.
Techniques for cutting metals, including workpiece securing, cutting oil use, and material types.
Inspect saw, switch, cord, and accessories; check for damage, loose parts, or misalignment.
Check power connection if the motor fails to start.
Clear saw dust from the clamp slot to enable blade removal.
Replace the saw blade if it is damaged or dull to improve cutting performance.
Diagram showing all parts of the reciprocating saw with their corresponding part numbers and descriptions.
Details the 3-year limited warranty against defects in workmanship and materials.
Lists exclusions such as abuse, misuse, wear and tear, and unapproved accessories.
Specifies warranty applies to original purchaser and excludes indirect or consequential damages.
Informs consumers of their specific legal rights and provincial variations in warranty coverage.
To Next Page