MasterCraft 058-8489-4 User Manual

IMPORTANT INFORMATION
12
AIR-POWERED 3-IN-1 NAILER 058-8489-4
Air system
• Always use clean, dry, regulated, compressed air at 4.8 to 7 bar (70 to 100 psi).
• Do not exceed the maximum or minimum pressures. Operating the tool at an inappropriate
pressure (too low or too high) will cause excessive noise, rapid wear, or misfiring.
• It is recommended that a filter-regulator-lubricator be used and be located as close to the tool
as possible.
• If a filter-regulator-lubricator is not installed, place up to 6 drops of pneumatic tool oil into the
air inlet plug before each use.
Wood density Nail size Compressor air pressure
≤0.6 g/cm
3
<1 1/4" (32 mm) brad nails 70 psi
≥1 1/4" (32 mm) brad nails 90 psi
<1" (25 mm) staples 70 psi
≥1" (25 mm) staples 100 psi
<1 1/4" (32 mm) T nails 70 psi
≥1 1/4" (32 mm) T nails 100 psi
>0.6 g/cm
3
<1 1/4" (32 mm) brad nails 90 psi
≥1 1/4" (32 mm) brad nails 110 psi
<1" (25 mm) staples 90 psi
≥1" (25 mm) staples 110 psi
<1 1/4" (32 mm) T nails 90 psi
≥1 1/4" (32 mm) T nails 110 psi
WARNING!
Potential hazard that could result in serious injury or loss of life.
•Do not free-fire this tool at high pressure.
• Keep hands and other parts of the body away from the tool’s discharge and
working areas when connecting the air supply. Failure to comply could lead
to serious injury or loss of life.

MasterCraft 058-8489-4 Specifications

General

Brand	MasterCraft
Model	058-8489-4
Category	Nail Gun
Language	English