MasterCraft 058-8489-4 User Manual

OPERATING INSTRUCTIONS
18
AIR-POWERED 3-IN-1 NAILER 058-8489-4
Firing modes
The Mastercraft
®
Air-powered 3-in-1 Nailer is equipped with a single sequential actuation mode that
follows the steps below:
• Press the safety stand (1) against the
workpiece
(fig H) .
• Pull the trigger (2) to drive the fastener
(fig H) .
• Lift the safety stand off the workpiece
and prepare to fire the next fastener.
• If the stand remains pressed against
the workpiece, successive fasteners
will be fired each time the trigger is
pulled.
Fastener depth adjustment
The Mastercraft
®
Air-powered 3-in-1 Nailer
has a depth adjustment dial below the trigger
to adjust the firing depth of fasteners
(fig I) .
Note: Refer to the graphic imprinted below
the trigger and adjust the firing depth
accordingly.
CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
• Operate the tool with the utmost care when connected with air compressor.
Failure to comply may result in moderate injury or damage to equipment.
MC-588489-12
fig H
2
1
MC-588489-09
fig I

MasterCraft 058-8489-4 Specifications

General

Brand	MasterCraft
Model	058-8489-4
Category	Nail Gun
Language	English