WARNING: Use proper circuit protection in order to avoid electrical
hazards, fire hazards, or damage to the rotary tool.
This rotary tool is wired at the factory for 110–120 V operation. It must be
connected to a 110–120 V 15 A time-delayed fuse or circuit breaker. In order
to avoid shock or fire, replace the power cord immediately if it is worn, cut, or
damaged in any way.
WEAR A DUST MASK THAT IS DESIGNED TO BE USED WHEN
OPERATING A POWER TOOL IN A DUSTY ENVIRONMENT.
WARNING: Dust that is created by power sanding, sawing, grinding,
drilling, and other construction activities may contain chemicals that are
known to cause cancer, birth defects. or other genetic abnormalities. These
chemicals include:
Lead from lead-based paints
Crystalline silica from bricks, cement, and other masonry products
Arsenic and chromium from chemically-treated lumber
The level of risk from exposure to these chemicals varies according to how
often this type of work is performed. In order to reduce exposure to these
chemicals, work in a well-ventilated area, and use approved safety
equipment, such as a dust mask that is specifically designed to filter out
microscopic particles.
To Next Page
Loading...
