ADJUSTING THE SANDING BELT TRACKING
– cont’d
NOTES:
b) Turn the tracking adjustment knob
clockwise to make the belt move
toward the tracking knob. Turn the
tracking adjustment knob counter
clockwise to make the sanding belt
move away from the tracking
adjustment knob.
c) Continue to make SMALL adjustments
until the sanding belt is tracking in the
centre of the rollers before using the
sander on the workpiece.
VACUUM ADAPTER
The vacuum adapter can be installed for
use with a workshop vacuum. Always use
a workshop vacuum wherever practical to
prevent dust from building up inside the
tool.
WARNING: Never use the vacuum
adaptor when sanding metal. Sparks could
ignite the dust collected in the vacuum.
1. Insert the small end of the vacuum
adapter (1) into the vacuum port (2)
located on the rear of the palm belt
sander (Fig. 4).
NOTE: Make sure the two locking knobs
(3) align with the two matching slots (4) in
the vacuum port before inserting the
vacuum adapter into the vacuum port.
2. Twist the vacuum adapter clockwise to
lock it into place.
To remove the vacuum adapter, twist it
counter clockwise and pull it from the
vacuum port of the tool.
To Next Page
Loading...
