WARNING: To avoid electrical hazards, fire hazards, or damage to the multi-
cutter precision saw, use proper circuit protection.
This multi-cutter precision saw is wired at the factory for 110–120 V operation. It
must be connected to a 110–120 V 15 A time delayed fuse or circuit breaker. To
avoid shock or fire, replace the power cord immediately if it is worn, cut or damaged
in any way.
Blade diameter ……………………..
WARNING: Dust created by power sanding, sawing, grinding, drilling and
other construction activities may contain chemicals that are known to cause
cancer, birth defects or other genetic abnormalities. These chemicals include:
Lead from lead-based paints
Crystalline silica from bricks, cement and other masonry products
Arsenic and chromium from chemically-treated lumber
Your level of risk from exposure to these chemicals will vary, according to how
often you do this type of work. To reduce your exposure to these chemicals, work
in a well-ventilated area and use approved safety equipment such as dust masks
that are specially designed to filter out microscopic particles.
Always wear eye protection.
Any power tool can throw foreign objects into your eyes, which could cause
permanent eye damage. ALWAYS wear safety goggles (not glasses) that
comply with ANSI safety standard Z87.1. Everyday glasses only have
impact resistant lenses. They ARE NOT safety glasses.
WARNING: Glasses or goggles that do not comply with ANSI Z87.1 could
cause serious injury if they break.
SAVE THESE INSTRUCTIONS FOR REFERENCE
DANGER: The laser light beam that is projected from the front of the laser
level can be dangerous to eyesight. Never allow anyone to stare directly into the
light. Staring directly into the light beam may result in serious eye damage.
To Next Page
Loading...
Need help?
General
