5. Pull on the recoil starter handle slowly until a slight resistance is felt (see figure 8). Then pull
quickly to start the engine. Return cord gently into the machine. Never allow the cord to snap
back.
6. If engine fails to start, repeat step 4. NOTE: After repeated attempts to start the engine, please
consult the troubleshooting guide before attempting again.
7. Once the engine has started and run for about a minute, move the choke lever about half way
towards the "OPEN" position. Wait another 30 seconds and then move the choke lever all the
way to the "OPEN" position.
8. Allow the generator to run for several minutes before attempting to connect any electrical
devices.
USING THE GENERATOR
12
To Next Page
Loading...