EasyManuals Logo

MasterCraft MIG 140 User Manual

MasterCraft MIG 140
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
MAINTENANCE
43
MIG 140 INVERTER WELDER 058-9305-6
Maintenance
The welder needs regular maintenance as follows:
Clean the dust, dirt, and grease periodically from the welder.
Remove the front panel from the welder to clear the accumulated dust and dirt for every six
months.
Replace power cord, ground cable, ground clamp or electrode assembly when damaged or
worn.
Repairs must be performed by a qualified service technician only.
Storage
Store the welder in a clean and dry location away from corrosive gas and excess dust at a
temperature of 10 °F
-120 °F and relative humidity of less than 90%.
It is recommended to repack the welder when transporting or storing the welder.
Before storage, clean the welder and its accessories and seal the plastic bag containing the
accessories.
WARNING!
Potential hazard that could result in serious injury or loss of life.
Unplug the welder before performing any maintenance or service.
Only use the welder after replacing or repairing any damaged parts or
accessories.
Use only recommended and properly rated replacement parts. Failure to
comply could lead to serious injury or loss of life.
MAINTENANCE
REQUIRED
DESCRIPTION
MAXIMUM SERVICE INTERVAL
Monthly As Needed
In-depth inspection Worn or broken
parts
X X
Repair or replacement Worn or broken
parts
X

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MasterCraft MIG 140 and is the answer not in the manual?

MasterCraft MIG 140 Specifications

General IconGeneral
BrandMasterCraft
ModelMIG 140
CategoryWelding System
LanguageEnglish

Related product manuals