OPERATING INSTRUCTIONS
24
MIG/FLUX-CORE WIRE FEED WELDER KIT 058-8195-2
4. Overhead position: This is the most
difficult welding position. For this
position, angle A should be maintained
at 60 degrees
. Maintaining this angle
will reduce falling of molten metal into
the nozzle
(fig Q)
.
Angle B should be zero degrees so that
the wire is aiming directly into the weld
joint. If excessive dripping of the weld
puddle occurs, select a lower heat
setting.
fig Q
MC-588195-18
To Next Page
Loading...
