TROUBLESHOOTING
30
MIG/FLUX-CORE WIRE FEED WELDER KIT 058-8195-2
Note: For further repair information, please call 1-800-689-9928.
Inconsistent arc or
wire feed.
1. Not enough drive roller pressure.
2. Spool hub tension too tight or
loose.
3. Contact tip worn or wrong size.
4. Rusty or corroded wire.
1. Tighten the drive tension adjustor on wire
feeder.
2. Adjust the wing nut on the spool holder.
3. Replace the contact tip.
4. Replace the wire.
PROBLEM POSSIBLE CAUSES SOLUTIONS
To Next Page
Loading...
