SKI/WAKEBOARD/SURF ROPE
Models
May be purchased from an authorized MasterCraft dealer or
aftermarket retailer.
Purpose
MasterCraft boats are equipped with watersports towing points as
standard equipment, and may also offer other optional pylons and
towers intended to be used to attach rope for skiing, wakeboard-
ing and surfing. Note that tow ropes should never be attached to
anything but the approved transom tow hook, pylon or tower. Care
should also be taken by all on board to pay attention to the tow rope
because it can snap back and hit people on-board when a skier or
wakeboarder lets go of it. Usually, the rope simply skips along the
water surface behind the boat, but it can become airborne, especial-
ly if it was taut prior to release.
Ski/wakeboard rope should never be attached to anything but ap-
proved pylons and towers because it may otherwise break free or
cause other items to break under load. People on board, as well as
skiers and/or wake boarders could be injured. Also, operators and
passengers should always pay attention to the tow rope when the
boat is underway because tow ropes can snap back into the boat,
which could result in injury.
Location
Attachment locations vary by model. See Guide to Individual Models
section in this Owner’s Manual to determine pylon and tower at-
tachments for each model. MasterCraft recommends stowing rope
when not in use. Feet, arms and bodies can become entangled with
rope left on the deck or seating; rope left loose behind the boat can
become airborne and swing around to strike people on board.
Operation
Failure to properly and securely attach to the tower, pylon or other
MasterCraft designated attachment locations for each model could
result in the rope coming loose. As noted in the above warning,
individuals could be injured if the rope is not secure.
To Next Page
Loading...
Need help?
General
