EasyManuals Logo
Home>MasterCraft>Boat>X23

MasterCraft X23 User Manual

MasterCraft X23
438 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #230 background imageLoading...
Page #230 background image
Troubleshooting
The bilge system is among the most important systems in the boat.
Attention should always be paid to proper operation.
If the boat does not automatically pump water out of the system
when the ignition key is ON, verify that the bilge switch is turned
to automatic.
If it is turned to automatic but still is not pumping when there is
evidence of water in the bilge as viewed through the center drain,
turn the switch to manual as needed to pump out the water. Be
certain to follow the instructions above and do not leave the
switch turned to manual after water is evacuated.
If the bilge pump(s) still does not work when turned to manual,
check the circuit breaker panel to ensure that electricity is mov-
ing between the switch and the pump. If the circuit breaker, which
is marked, has tripped, reset it to ON.
If the bilge pump(s) still does not work, it may be evidence of
debris in the system or failure of the ballast pump impeller, which
must be replaced on a regular basis as detailed in the Care and
Maintenance section of this Owner’s Manual. This is a serious
concern. The bilge system keeps the boat from filling with excess
water that may cause imbalance in the boat’s trim. Under the
worst possible conditions, the boat can sink. If the system fails
while on a body of water, return to shore IMMEDIATELY! Have
all people on-board put on PFDs (personal flotation devices).
Signal for emergency help. If persons on-board have working cell
phones, contact help. After returning to shore, take the boat to
an authorized MasterCraft dealer as soon as possible for repairs
and do not use the boat again until it has been properly repaired.
An inoperable bilge system can result in the boat taking on
excessive amounts of water, resulting in significant damage
to the boat, even sinking. Persons on board should wear PFDs
and be prepared to abandon ship if the boat is on an outing.
Operators should signal for emergency help and return to shore
IMMEDIATELY and have the boat repaired. Failure to follow
instructions can result in serious injury or death.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MasterCraft X23 and is the answer not in the manual?

MasterCraft X23 Specifications

General IconGeneral
BrandMasterCraft
ModelX23
CategoryBoat
LanguageEnglish

Related product manuals